Victron - Phoenix Charger Control [REC010001110] Inverter VE.Direct 48V 230V

Victron - Phoenix Charger Control [REC010001110] Inverter VE.Direct 48V 230VThe Charger Control panel provides remote control and monitoring of the charge process with LED indication of the charger status. In addition, the remote panel also offers output current adjustment that can be used to limit the output current and thus the power drawn from the AC supply. This is particularly useful when operating the charger from limited shore power or small gensets. The panel can also be used to change the battery charging parameters.

When the charge voltage of a 24V battery system increases to more than 27V

but if this cable is too long or too short it can be replaced by one of these cables

Argofet isolators allow simultaneous charging of two or more batteries from one alternator (or a single output battery charger)

Easily mount a BMV-700 series or MPPT Control on a wall

Updated in mid-2023 to a dual tracker design

For a full list of available parts

The battery charger combines speed with efficiency through a smart adaptive algorithm that extends battery life

The self-discharge doubles for every increase in temperature with 10°C

The input for the charger is 230V at 50/60HZ

capacitive or inductive (such as the coil of a high-power contactor)

Bus BMS / VE

Bus interface